Want to see this answer and also more?

Experts space waiting 24/7 to carry out step-by-step solutions in as rapid as 30 minutes!*

See Answer
*Response times may vary by subject and also question complexity. Median an answer time is 34 minutes for paid subscribers and also may be longer for promotion offers.

You are watching: Determine the phase or phases in a system consisting of h2o at the following conditions


Q: the 65mm-diameter A992 steel column is subjected to the torques shown. Determine the angle of twisted o...

A: Given data:The diameter the shaft, d = 65 mm.


Q: Water flows with a pipe at an average temperature of T∞ = 70°C. The inner and also outer radii that the ...

A: Determine the warmth flux in ~ the external surface of the pipe.


Q: Air is compressed stability by a reversible compressor indigenous an inlet state that 100 kPa and also 300 K to an...

A: Obtain the push ratio. 


Q: The wheel consists of a 5.0-kg pickled in salt of radius r 260 mm through hub and spokes of negligible mass. The wh...

A: Show the diagram reflecting a wheel placed on a yoke rolling on a one surface. 


Q: Two pounds the carbon dioxide (CO2) as suitable gas executes a Carnot power cycle while operation bet...

A: Draw the p-V diagram because that a Carnot cycle:


Q: I need answers to concerns 4, 5, and 6 pertaining to the print provided.Note: A tutor keeps puttin...

A: Answer to question no. 4The in its entirety dimension of this part (diameter x length) room Ø1.5 systems x 1.89...


Q: 200 W/m K, yet the thermal conductivity of pole 2,3-130 Two very long, slender rods the the same diam...

A: Click to view the answer


Q: A resistance heater is inserted inside a rigid insulated tank containing 0.25 kg the nitrogen for the p...

A: Mass that nitrogen in the tank = 0.25 kgThe worth of existing = 0.3 AmpsThe worth of resistance that heat...


Q: I need help with concern number 15 the is pertaining come the print provided.

A: 15.The unidirectional mechanism is used below for the dimension placing. The unidirectional device is th...


Q: Please price The test part d and e from this problem The check is akredytacji resolved thank you

A: Since we only answer as much as 3 sub-parts, we’ll answer the an initial 3 parts. Please resubmit the question...


Q: The flywheel is rotating v an angular velocity wo 1.97 rad/s at time t 0 as soon as a talk is applied...

A: Given:Omega is angular velocity.Alpha is angular acceleration.


Q: A round is thrown vertically upward through a rate (vo) the 15 m/s in ~ an initial place of so= 10 m. ...

A: Hello. Because your question has actually multiple sub-parts, we will certainly solve first three sub-parts for you. If y...


Q: (a) construct Mohr's circle because that an aspect in a uniaxial state the stress(b) use this Mohr's circle ...

A: Procedure for Mohr’s circle:


Q: I need assist solving difficulties 7, 11, and also 12 pertaining to the print listed below.

A: 7 partHidden present are provided to suggest the concealed parts that the object and also these lines are dotted li...


Q: A piston-cylinder device initially consists of 0.07 m3 the nitrogen gas at 130 kPa and also 120oC. The nitrog...

A: (a)The initial and final conditions of the procedure is provided as:


Q: Weight and also BalanceFind the Empty weight CG place for the following tricycle equipment aircraft.Each ...

A: Consider the moment diagram that the tricycle equipment aircraft.


Q: I need assist answering difficulties 10, 11, and also 12 pertaining come the print provided in the attachment.

A: 10.The radius the the 4 corners is 0.44 units.


Q: I need troubles 4, 5, and also 6 fixed pertaining to the print listed below.

A: Answer to concern no. 4For the four screw threaded holes not marked “A”, one underconstrained tolera...


Q: 7.58 figure PZ.58 shows a gas generator power plant making use of air as the working fluid. The accompanying t...

A: (a) Since at the power plant both turbine and compressor space involved, compose the expression for the ...


Q: At the beginning of the compression process of an air standard Otto cycle, p1 = 1 bar, T1 = 300 K. T...

A: Note: We will answer the first 3 subparts due to the fact that the precise 3 room not specified. You re welcome submit a new q...


Q: True or False: The rest command requires two separate points as soon as breaking a circle.

A: The break command is offered to break the selected object between two points.


Q: ㅮ Pearson's MyLab & Mastering-×圏MasteringEngineering grasp in、Сhttps://session.masteringenginee...

A: Given, r= 1.5 m θ = 0.7 t radian and also z= -0.5t m


Q: I need help solving difficulties 10, 11, and 12 pertaining come the print noted below.

A: 10.The cross-section view is offered in this drawing.11.The pitch of the exterior thread in this drawin...


Q: A textile machine with a fixed of 5000 kg need to be isolated from transmitting force to thefoundation. ...

A: The offered data is presented below,


Q: A vapor-compression refrigeration device circulates Refrigerant 134a in ~ a rate of 0.15 kg/s. The ref...

A: Given refrigerant R-134a compressor in ~ inlet isso think about the isentropic enthalpy in ~ compressor exi...


Q: I need assist with the correct pairings the the all the offered terms v their corresponding phrases.

A: (C) Correct pairings that the every the offered terms v their particular phrases.


Q: Point A the the circular disk is in ~ the angular position 0 0 in ~ time t 0. The disk has actually angular veloci...

A: Draw the free-body diagram of the circular disk. 


Q: A spherical container through an within radius r1 = 1 m and an external radius r2 = 1.05 m has actually its within su...

A: Using differential equation for warmth conduction,


Q: I need help with problems 1, 2, and 3 pertaining to the print listed below.

A: A datum is a hypothetical line, point, axis or plane. A datum attribute is a physical function which ca...


Q: A 50kg copper block initially at 180 levels C is dropped right into an secluded tank comprise 90 together of w...

A: first we have actually to consider the total change in internsl power of he mechanism as shown belowhere one of...


Q: A component has been designed and its dimensions can not be changed. To minimize its deflections under the...

A: Deflection the beam is in inversely regarded the modulus of elasticity. The material having actually the max...


Q: A dam 30.5m long retains 8 m of fresh water and also is inclined at an angle of 60 degrees. Calculate the...

A: Write the expression to attain the length. 


Q: The portrayed pulley is released from rest. What is the acceleration that B and how much time isneed...

A: Draw the cost-free body diagram of the block A as presented in number (1).


Q: The stones space thrown turn off the conveyor with a horizontal velocity that 10 ft/s as shown. Identify the...

A: Given, V0= 10 ft/sech =100ftc=1d =10g= 32.17 ft/sec


Q: True or False: Objects on a layer the is rotate off have the right to still be modified

A: The AutoCAD hides the objects existing in a layer the is turn off. The objects space only concealed and...


Q: QUESTION 4Derive the adhering to expression because that the diffuser efficiency:T2s1TIT21TT

A: Diffuser effectiveness is identified as the proportion of actual change in enthalpy to the isentropic actual ch...


Q: I need assist solving problems 1, 2, and 3 pertaining come the blueprint fastened below.

A: There are 4 surface texture symbols are supplied in the given drawing as shown in the fig.


Q: If a ball has a volume of .52 cubic feet, what is the bouyant pressure on that if that is thrust under wate...

A: Write the expression the buoyant force. 


Q: Liquid flows at stable state in ~ a rate of 2 lb/s v a pump, which operates come raise the elevati...

A: Write every the noted values in the question to figure out the parameter to be determined. In the p...


Q: The dashed heat that shows up around the sheet of a layout:a. Have the right to be erased if neededb. Is top top its ow...

A: The dashed line that appears around the sheet of a layout shows a intuitive indication that the area that ...


Q: I’m having actually trouble in my statics course. We space covering moments and I am confused about (1) what to...

A: The minute of force about any suggest can be given by vector equation as,


Q: True or False: there is just one model an are allowed in a illustration file.

A: In AutoCAD, the model room is the illustration environment and is provided to create and visualize the 3D mo...


Q: A concentric cylinder viscometer might be developed by rotating the within member the a pair of very closely fit...

A: Write the expression the torque. 


Q: A piston–cylinder assembly fitted with a slowly rotating paddle wheel has 0.17 kg of air, initi...

A: Assumption:


Q: Technician a says radial ply tires are an ext rigid in the sidewall area than predisposition ply tires. Technic...

A: Technician A is wrong because bias-ply tires have fibres that nylon arranged in a diagonal line manner to ...


Q: Liquid water in ~ 200 kPa and also 20 degress celcius is cook in a chamber by mixing it with superheated ...

A: Draw the schematic diagram of the mix chamber as shown in figure (1). 


Q: A 3590-lb automobile travels increase the 7-percent incline shown. The car is based on a 45-lb aerodynamic dr...

A: Draw the cost-free body diagram of the car. 


Q: Air in ~ 30°C is contained in a piston-cylinder assembly, as presented in the figure. The piston has a wei...

A: Draw the schematic chart of the given system as displayed in number (1).


Q: Fluid A has a dynamic viscosity of 4.54 centipoise and also a certain gravity that 1.51. What is the kinem...

A: The adhering to data is offered to us:Dynamic viscosity, μ = 4.54 cP.Specific heaviness of fluid A, S = 1....


Q: Air is broadened in a multi-stage axial circulation turbine, and also the push drop throughout each phase is very...

A: Write the an easy equation of thermodynamics with ds = 0.

See more: Which Of The Following Describes The Embryonic Period, Psych Chap 8 Flashcards


3.6 determine the phase or phases in a device consisting ofH.O in ~ the adhering to conditions and also sketch p-v and also T-vdiagrams reflecting the location of every state.(a) ns 10 bar, T = 179.9°C(b) p 10 bar, T= 150°C(c) T 100 C, ns =(d) T 20°C, p(e) ns 1 bar, T =-6°C.3.7 The complying with table lists temperatures and certain volumesof water vapor at 2 pressures:I= 0.5 bar.- 50 bar.p 1.5 MPap 1.0 MPa(m/kg)(m'/kg)T(C)T(C)0.13252000.20600.22750.24802000.14832402802402800.1627Data encountered in solving troubles often carry out not fallexactly on the net of values provided by residential or commercial property tablesand straight interpolation between adjacent table entriesbecomes necessary, using the data listed here, estimate(a) the certain volume in ~ T 240°C, ns 1.25 MPa, in m'/kg.(b) the temperature at p 1.5 MPa, v 0.1555 m/kg, in °C.(c) the specific volume at T 220°C, p 1.4 MPa, in m'/kg.3.11 for each case, determine the details volume at theindicated state. Situate the state top top a map out of the T-vdiagram.(a) Water at p 1 bar, T 20°C. Uncover u, in m'/kg.(b) Refrigerant 22 at p 40 lbl/in.', x = 0.6. Discover v, in ft'lb.(c) Ammonia at ns = 200 lbf/in., T= 195"F uncover v, in ft'lb.

3.17 recognize the volume, in ft', of 2 lb the a two-phaseliquid-vapor mixture of Refrigerant 134A in ~ 40°F v aquality the 20%. What is the pressure, in Ibf/in.?I3.18 A two-phase liquid-vapor mixture of ammonia has aspecific volume that 1.0 ft'/lb. Determine the quality if thetemperature is (a) 100°F, (b) 0°F. Situate the claims on asketch the the T-v diagram.3.26 A closed, rigid tank includes a two-phase liquid-vapormixture the Refrigerant 22 originally at -20°C with a qualityof 50.36%. Energy transfer by heat into the tank wake up untilthe refrigerant is in ~ a final pressure that 6 bar. Recognize thefinal temperature, in °C. If the final state is in the superheatedvapor region, in ~ what temperature, in °C, walk the tankcontain just saturated vapor?3.27 Water vapor is cooled in a closed, strict tank native 520°Cand 100 bar to a last temperature that 270C. Recognize thefinal pressure, in bar, and sketch the procedure on T-v and p-vdiagrams3.35 3 kg the Refrigerant 22 undergoes a procedure for whichthe pressure-specific volume relationship is pvThe initial state that the refrigerant is 12 bar and 60°C, andthe last pressure is 8 bar. Kinetic and potential energyeffects room negligible. Determine the work, in kJ, because that the-0.8= constant.process